When we install bearing isolators, such as the Inpro VBX and either a uni-directional vent or expansion chamber, the constant level oiler empties. What is the cause of this?
Because the uni-directional vent only vents air as a result of the pressure build up within the bearing housing, it is creating an atmospheric condition that is different from that in and about the constant level oiler. The same concept holds true for the expansion chamber. The diaphragm in the expansion chamber is taking up the expanding air in the bearing housing, however, this air is contained and is creating a different atmospheric condition in the bearing housing from that at the constant level oiler. In these situations, a good easy conversion for the customer is to use either the closed system Opto-Matic or Watchdog oilers. These can be used with the uni-directional vents and/or expansion chambers because they are vented to the bearing housing.
Because the bearing housing is closed off to atmospheric pressure, this pressure,in the form of expanded air, needs some place to go. The seals of the bearing housing are made to withstand small amounts of pressure. By using an expansion chamber, you are providing a place for this expanded air to go, causing the seal not to breathe. If the seal were allowed to breathe contaminants could get into the system.
With the Watchdog oiler, when equipment is coming up to speed, oil from the oiler is being allowed into the bearing housing, leading to overfilling of the housing. What is causing this to happen?
In some instances it has been noted that upon equipment coming up to speed that the oiler will feed into the bearing housing causing an overfill situation. In these applications, it has been observed that, if the reservoir is left off of the surge body, a flow pattern can be observed through the surge body. In this situation, it is necessary to mount the oiler away from the housing to take the flow pattern out of the situation.